Fixing a Super proLIGHT 1000 CNC Mill

At school this week I set out to get the ancient intelitek proLIGHT mill back to running order.
To start, I checked out all the motor-brushes and fuses.

The brush for the Z-Axis needed to be cleaned up, and the fuse on the controller was out of place.

After a little TLC, I had it back into mostly operational order. The next logical step was to play with some Aluminum and MasterCAM!

So I made the NC code to cut “CT” in some scrap

Closer in-


Leave a Reply

Your email address will not be published.